GUI side modulesMain DSP side modules


Screenshot
Source
RH-Booster

Boost / distort signals, range stays within -10v / 10v

- Added mode selection : 0dB, -6dB ( OSC range -5 / 5 volts )
- Amount is scaled down a bit.

Credit :
Original Waveshaper Code was posted on MusicDSP.org archive by Bram de Jong.
Foldback2
Screenshot
Source
RH-Foldback2
*New* August-13th-2006

Folds the Signal with a fast sine code snippet,
the treshold point is controlled by a list pin choice.
Gain input boosts the signal to fold the waveform, range is limited.

-2 List selections :
mode 0 : 0 dB response --) -10 / 10 volt range
mode 1 : -6 dB response --) -5 / 5 volt range
RH-Limit2
Screenshot
Source
RH-Limit2

Limits the Signal at the given threshold.

-Output Level added
-Preboost added.


RH-M2v
Screenshot
Source
RH-M2V

Converts Volt midinotenumbers from KDL Midi2Volts to SE PitchVoltage.



Screenshot
Source
RH-Softclip

-Clips the incoming signal, use clipfactor for clipstrength.
-This module uses code with a Fast aTan function.
On my Amd 2100+ about : 0.150 %

-Normalise added.

Credit : Original code from MusicDSP.org.
RH-Waveshaper
Screenshot
Source
RH-WaveShaper

This shapes waves in a very nice way, range stays within -10v / 10v

-Mode selection : 0dB,-6dB ( OSC range )

-Amount values between -9.99v and 9.99v.
-Level out wave afterwards if needed.

Credit : WaveShaper code by Patrice Tarrabia and Bram de Jong.
RH-Waveshaper2
Screenshot
Source
RH-WaveShaper2

Dual output version, left is the opposite of right and visa versa.
Gives the effect of "panning".

-Mode selection : 0dB,-6dB ( OSC range )

-Amount values between -9.99v and 9.99v.